Titanium vs Stainless vs Aluminium
Three metals, three different answers. Titanium sits between aluminium and steel on weight but beats both on strength-to-weight and chloride corrosion. This page is the selection shortcut.
Property comparison
| Property | Titanium Gr2 | 316L stainless | 6061-T6 aluminium |
|---|---|---|---|
| Density | 4.51 g/cm³ | ~8.0 g/cm³ | 2.70 g/cm³ |
| Min tensile | 345 MPa | ~485 MPa | ~290 MPa |
| Strength-to-weight | high | moderate | moderate |
| Seawater / chloride corrosion | excellent | good (pitting risk) | poor (galvanic/pitting) |
| Max service temp | high (~1668 °C melt) | high | low (~660 °C melt) |
| Cost per kg | high | moderate | low |
When titanium is the right call
Choose titanium when chloride corrosion + weight both matter: seawater piping, heat-exchanger tubes, desalination, chemical internals, marine hardware. Stainless pits in warm chlorides; aluminium is attacked and galvanically risky. Titanium's passive TiO2 film shrugs off seawater at ambient temperature.
When stainless or aluminium wins
Stainless wins on cost for non-chloride structural and food service. Aluminium wins where weight is the only driver and loads/corrosion are mild (frames, housings). Titanium is over-specified — and over-priced — for those jobs.
Weight saving in practice
At equal volume titanium is ~44% lighter than steel. Where titanium's strength lets you thin the section, part-level weight savings grow further. Use the weight calculator to compare your actual part.